↑ Return to Contact

Print this Page

Me

You can contact me for any work you need.

pic18-starter-kit-rtc

email: info@cerescontrols.com
cel phone: +(507)66168542

Permanent link to this article: http://cerescontrols.com/contact/me/

8 comments

Skip to comment form

  1. Javier

    Beforehand thank you very much. I am new to this and I need a little help, I have a doubt about the physical connection of the speed controller to the computer, the drive is connected to the computer by an Ethernet network cable, or needs a special one, besides the ip address of the drive, how do you get it? it is necessary to connect the inverter to the internet and from there get the ip address, jejej I have many doubts and wanted to know if I could solve them

    1. Rangel Alvarado

      I sent you an email but basically the physical connection is a straight ethernet cable to the VFD Ethernet Board. You could stablish communication using and USB-UART cable by removing the display and connectiong serially to that port or using the CAT5 cable to the ethernet card, then use 9000XDrive to communicate.

      If you want to do IoT then you must have a IoT gateway with data acquisition and command capabilities, also integrate with IBM, AWS, Google is appart.

  2. KALPAK AWALE

    SIR CAN U PROVIDE ME WITH UR WHATSAPP NUMBER.

    1. Rangel Alvarado

      I updated the contact/me link, now you have my number.

  3. KALPAK AWALE

    hello SIR…….my name is kalpak awale…..i am final year MTECH student. i am working on barin computer interface project (BCI). I want to get the signals from neurosky mindwave onto labview. am going throught urs EEG LABVIEW . SIR IF I GET ANY DIFFICULTY PLEASE HELP ME.

    1. Rangel Alvarado

      No problem, if it is in my possibilities I will

      1. KALPAK AWALE

        THANK-YOU very much sir for your feedback

        1. KALPAK AWALE

          HELLO SIR, i have send you a message on your mail id : info@cerescontrols.com

          waiting for ur reply sir…

Leave a Reply

Your email address will not be published. Required fields are marked *